When block connects, utility allows reading and writing by pressing buttons read and write respectively.

TB RJ45 Pinout. Cross Over Pinout A crossover cable utilizes two different RJ45 pinouts for the two ends of the cable.

They share inputs and data across communication circuits, this helps to cut down on wire and the number of sensors used.

The computers are programmed with base parameters and utilize sensor inputs to make adaptations and control component outputs as needed.

When replacing your DME, a used replacement is not an option.

In the past, we use to be able to grab a DME from a donor vehicle with a matching part number.

Late model BMWs utilize an anti-theft system preventing swapping from vehicle to vehicle.

With that said, there are companies popping up that claim to be able to program a used DME to match your vehicle.

I dont have any personal experience with this method, however it is worth a phone call or a web search to see if it is an option for your vehicle.

At the minimum, if you buy a new unit, you will have to code, program the DME.

Remember your car may have been serviced before and parts replaced with different size fasteners used in the replacement.

Protect your eyes, hands and body from fluids, dust and debris while working on your vehicle.

If working with the electrical system, disconnect the battery before beginning.

Never work on your vehicle if you feel the task is beyond your ability.

Our vehicle may vary slightly from yours as models do change and evolve as they grow older.

Questions or want to add to the article Leave a comment below.

The DME is located on the left side of the engine compartment mounted in the e-box.

At the corner of the E-box, pull the harness up out of mounting slot and lay aide.

For the best experience on our site, be sure to turn on Javascript in your browser.

A RJ45 connector is a modular 8 position, 8 pin connector used for terminating Cat5e or Cat6 twisted pair cable.

A pinout is a specific arrangement of wires that dictate how the connector is terminated.

TB has surpassed A and is seen as the default wiring scheme for twisted pair structured cabling.

Fgtech Galletto read BMW M3 Siemens MSS54 via BDM If you are unsure of which to use, choose B.

Dme Ms42 Pinout